Replacements can range from $1,800 to $3,400. Depending on the repair shop and technicians, labor charges can range from $500 to $1,200. Here’s a quick overview of the average transmission cost: Remanufactured transmission – $1,300 to $3,400.
How much is labor for transmission replacement?
Transmission repair normally costs around $3,000—with $2,500 going towards parts and $500 to labor. If you have a larger or luxury vehicle the parts and the labor cost can increase up to $10,000.
How long does it take a mechanic to replace a transmission?
Three to four days. It usually takes three to four days to replace or repair the entire transmission system. But it depends on the vehicle models and transmission types. It might take a little longer if other parts with transmission also need repair.
Is it cheaper to rebuild or replace a transmission?
A transmission replace is the most expensive option when fixing your transmission. In many cases you will hear this referred to as “re-manufactured.” Basically, the manufacturer will replace parts that have gone bad with modified parts. This is an option if the transmission is too damaged to even consider a rebuild.
Is it worth fixing a transmission?
Rebuilding a transmission can save you a lot of money over the short-term, while keeping car payments out of your monthly budget. For many, rebuilding their transmission is worth the initial cost. Rebuilding a transmission may cost you twenty-five hundred dollars or more, which is a significant chunk of change.
How long does it take a dealer to replace a transmission?
The amount of time required to replace a transmission often depends on the type of transmission and the vehicle. It usually only takes a day or two to replace a transmission in most rear wheel vehicles. However, some late-model, front-wheel drive vehicles can be quite labor-intensive and take three to four days.
How many hours does it take to remove and replace a transmission?
The good news is quite often, it doesn’t take more than a day or two to replace a transmission. Of course, it depends on the model and make of your car, and the type of transmission it is. If you have a rear-wheel drive vehicle that’s commonplace on the road, plan on being without your vehicle at least a day or two.
Do you have to remove engine to replace transmission?
Hello – no, you do not have to remove the engine in order to remove and service the transmission. As with most front-wheel drive vehicles, dropping any combination of the engine/transmission or both requires some extra equipment, and caution, but it is quite manageable.
Why is transmission repair so expensive?
Transmission repairs are so expensive because of the diagnosis involved in figuring out which part of the transmission has failed. For instance, assume you’re driving along on your way to work, and you’ve come to a stop at a red light.
Is it difficult to replace a transmission?
Depending on the year, make and model of your vehicle and the shop labor costs in your area, you can expect to save between $550 to $1,250 or more. The job of removing and replacing an automatic transmission is not tremendously difficult – it’s just a matter of being prepared, being safe, and following instructions.
Is fixing automatic transmission expensive?
Replacing a transmission is one of the most expensive repair jobs you can go through with your vehicle. You need to take your car somewhere you trust with experienced, honest technicians. … Automatic transmissions will cost anywhere from $1,000 to $2,000 to repair and can even range up to $3,500 for a full replacement.
Can you sell a car with a bad transmission?
Yes, you can sell a car with a bad transmission. There are no laws against selling a vehicle with mechanical problems. However, you must be transparent with any buyers about the condition of the vehicle. Make sure to describe the problem with the vehicle, whether it runs or not and whether it is repairable.
What causes a transmission to go out?
Low automatic transmission fluid, one of the most common causes of a slipping transmission, reduces the hydraulic pressure necessary to properly shift. If there’s not enough fluid or it is starting to lose its effectiveness in lubricating and cooling, the transmission will perform poorly or stop working altogether.