Can I reset my own check engine light?

The on-off method is the equivalent fix for a vehicle’s check engine light. It forces the computer to refresh its saved state through a reboot. Simply place your key into the ignition and turn it on for 1-2 seconds, then turn it off for 1-2 seconds. Repeat this step three or four times.

How do you turn off check engine light without disconnecting the battery?

Turning the Ignition On and Off

Switching the ignition on and off is also one method of hard reset without disconnecting batteries. Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step. Once it is done, see if the engine check light is still coming on or not.

Does disconnecting battery clear codes?

Leaving the battery disconnected for about 15 minutes will ensure the vehicle systems will completely reset when you reconnect the battery. Secure the negative cable back to the terminal and cover it with the cap (if applicable). Disconnecting the battery will clear the error codes and reset the check engine light.

How long do I have to drive to reset OBD?

Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

IT IS IMPORTANT:  How much does it cost for AutoZone to install a battery?

How do you erase trouble codes?

How to Clear OBD-II Codes

  1. Hook an OBD-II scanner to the car’s diagnostic port. This outlet is on the driver’s side, under the dash and usually near the steering wheel.
  2. Turn the scanner on.
  3. Turn the car on.
  4. Wait for the trouble code to appear on the scanner. Press the “Clear” button on the scanner to clear the code.

How long does it take for a car computer to reset?

The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.

How long do you leave battery disconnected to reset ECU?

Disconnecting the battery for a short time may not do the trick because the car’s computer, or ECU, still has some current in it. Waiting for over 15 minutes after disconnecting the engine will help ensure the equipment is reset.