Water is abrasive and accelerates the wear of the brushes and the comm surface, essentially taking life away from your new motor very quickly. Our motors don’t really require a break-in before use, but you can run them on low voltage (4-6V) for a minute or two both directions to seat the brushes.
Do you have to break in an electric RC motor?
Sealed endbell motors need a lot of running to break in their hard compound brushes. Running it partially submerged in water helps break them in faster. … You don’t want the motor going at full speed but you also don’t want it going too slowly. With your motor submerged in the water, let it run for about 10 minutes.
Do you have to break in a brushless RC motor?
no such thing needed for a brushless motor. the break in was for brushed motors because it has… brushes that touch a moving armature. there is 0 contact in a brushless motor.
Can a brushed motor be submerged in water?
Brushed motors are well known for being able to survive wet conditions. They can even run under water—completely submerged. Brushed motors are frequently said to be waterproof and are actually a great example of the difference between being able to do something and being able to do something without long-term damage.
Can you oil a brushed motor?
Brushed motors equipped with bushings requires timely maintenance in order to stay in top running condition. … Failure to lubricate the bushings regularly may result in shorter motor lifespans. Use an oil made for electric motors such as 3-in-1 Oil, or a special motor bushing lube found at your local hobby shop.
How long should a brushed RC motor last?
Brushed motor life is limited by the brush type and can attain 1,000 to 3,000 hours on average, while brushless motors can attain tens of thousands of hours on average, as there are no brushes to wear. The limiting factor is the wear on the bearings.
How do I keep my brushed motor cool?
There are a few things you can do to keep your motors running cool.
- Give it air! One of the easiest ways to make sure your motor stays cool is to make sure it is properly ventilated and getting enough air. …
- Fan it! …
- Sink the heat! …
- Bearings in mind.
How do you break in a RC brushless motor?
What do I need to do to properly break in a brushless motor? Just run it, no break in needed. No need to break in a brushless motor. Brushed motors people used to break them in to get the comm brushes to match up with the commutator and also to break in bushings if the motor didn’t have bearings.